Accessories (3700)

Locating insert for 2.5 gallon single bottle sampling in standard base.  Positions single container for proper sample routing.  Used with the Model 3700 Portable Full-Size Sampler. Estimated Shipment Time (After...

Conversion kit to adapt center section for single container sampling on Models 3700 and 3700C Samplers.  Includes pump tubing, float shutoff and float cage.   Single container sampling with a 2.5...

Suspension harness for 3700 Series and 6700 Series Samplers.  Three-point, used on portable full-size and compact versions.  Constructed of stainless steel, 37.5 inches. Estimated Shipment Time (After Receipt of Order): ...

Model 1640 Liquid Level Sampler Actuator.  This actuator is a device used in conjunction with an ISCO wastewater sampler to begin a sampling routine when the liquid level reaches a...

ProHanger bracket for suspension of equipment in manholes.  Stainless steel and extendable for manholes 18 to 24 inches in diameter.  Rated for weights up to 200 lbs. Note:  This item...

External 12 VDC connect cable, 6 ft.  For powering portable ISCO Sampler or Flowmeter from an external 12 VDC source such as an automotive or deep cycle marine battery.  Terminates...

ISCO Sampler to ISCO Flowmeter connect cable, 25 ft. (7.6 m).  For use with older ISCO flowmeters.  Not for use with the Model 5800 Sampler or 2100 Series Modules. Note: ...

Distributor arm assembly for Model 3700 Portable Sampler using 24 bottle configuration (glass or polypropylene).   A distributor arm nut is required to hold the distributor arm in place. Estimated Shipment Time (After...

Jumbo base used on Model 3700 Full Size Portable Sampler.  Light-colored ABS plastic construction with foamed in-place insulation.  Includes bales for connection to the handles on center section.  Estimated Shipment...

Base assembly for Model 3700 Full Size Portable Sampler.  Manufactured of ABS plastic, rated for standard thermal resistance factor of R-11.  Includes bottle ring retaining straps mounted to inside bottom of...

Distributor arm assembly for Model 3700 Portable Sampler using 4 bottle configuration (glass or polypropylene).   A distributor arm nut is required to hold the distributor arm in place.   Estimated Shipment Time (After...

Sampler to flowmeter cable with pigtails on one end, 50 ft. (15 m) length.  Provides connector on one end and all six wires (A-F) on the other end.  Connects to...