Pump Parts & Accessories

Aqueous seal for Models 100DM and 100DX Syringe Pumps.  White-translucent, ultra-high molecular weight polyethylene. Maximum pressure rating 7,500 psi (517.1 bar). This seal has better wetting properties, which makes it a good choice...

Aqueous seal for Model 260D Syringe Pump.  White-translucent, ultra-high molecular weight polyethylene. Maximum pressure rating 7,500 psi (517.1 bar). This seal has better wetting properties, which makes it a good choice for aqueous solutions. ...

Aqueous seal for Model 500D Syringe Pump.  White-translucent, ultra-high molecular weight polyethylene. This seal has better wetting properties, which makes it a good choice for aqueous solutions.  It is also the best choice...

Back up ring for the primary seal on the Models 65D, 65DM and 65HP Syringe Pumps. This item has a lead time of 28-32 days

Ball nut assembly. This item has a lead time of 28-32 days

Ball screw assembly.  Used on the Models 260D, 260HLf, 260HP, 500D, 500HLf, 500HP, 500HPx, and 1000D Syringe Pumps. This item has a lead time of 28-32 days

Basic D-Series syringe pump controller for operation of up to 4 D-Series pumps. Built in control connections for Digital Inputs/Analog Inputs and Digital Outputs for remote pump control signals and...

Basic D-Series Syringe Pump Controller With 6 Installed 0-10 Volt Output Cards.  Maximum of 12 cards (0-10 Volt only) possible on basic controller by purchasing additional 0-10 Volt output cards. ...

Basic D-Series Syringe Pump Controller With 6 Installed 4-20 mA Output Cards.  Maximum of 12 (4-20 mA) cards possible on basic controller.  This controller is modified to allow 4-20 mA...

Basic Controller with 6 installed 4-20mA output cards (maximum of 12 (4-20mA) cards). Can control up to 4 D series pumps. This controller also contains the standard input and output...

Bearing cover plate.  Manufactured of aluminum. This item has a lead time of 1-4 days

Blank cylinder cap. This item has a lead time of 19-23 days

Calibrated preamplifier assembly (a/k/a pressure transducer) for Models 65DM, 100DM, 100DX and 260D Syringe Pumps. This item has a lead time of 3-7 days

Circuit board assembly for the Model 100DM Syringe Pump motor drive unit.  Pump identification chip programmed. This item has a lead time of 28-32 days

Circuit board assembly for the Model 100DX Syringe Pump motor drive unit.  Pump identification chip programmed. This item has a lead time of 28-32 days

Circuit board assembly for the Model 260D Syringe Pump motor drive unit.  Pump identification chip programmed. This item has a lead time of 12-16 days

Circuit board assembly for the Model 500D Syringe Pump motor drive unit.  Pump identification chip programmed. NOTE:  If using the Model 500HP Syringe Pump, order the following instead: Circuit Board Assembly for...

Circuit board assembly for the Model 500HP Syringe Pump motor drive unit.  Pump identification chip programmed. This item has a lead time of 28-32 days

Coded pump identification chip for Model 100DX Syringe Pump. This item has a lead time of 28-32 days

Coded pump identification chip for Model 260D Syringe Pump. This item has a lead time of 28-32 days