Repair Parts (Signature Area Velocity)

Front panel label with built-in keypad assembly for Signature® Flowmeter. Estimated Shipment Time (After Receipt of Order):  7 Day(s)

Cord grip fitting for cable diameters from 0.250 to 0.375 inches (6.35 to 9.53 mm).  For user-supplied cables within this diameter range. Estimated Shipment Time (After Receipt of Order):  7...

Cord grip fitting for cable diameters from 0.375 to 0.438 inches (9.53 to 11.13 mm).  Accommodates the passage of wide cables into the Signature® meter housing.  This includes TieNet™, power...

Bottom connector plug for Signature® Flowmeter.  Used to seal unused cable entry ports on the bottom of the meter.  Ensures IP66 protection.  Manufactured of black Delrin plastic. Estimated Shipment Time...

Kit for replacement of USB hub on Signature® Flowmeter.  Includes the following: Micro USB assembly Micro USB strap Micro USB cap Retaining ring Appropriate o-rings Estimated Shipment Time (After Receipt...

Power supply assembly used on Signature® Flowmeter. Estimated Shipment Time (After Receipt of Order):  7 Day(s)

Fuse, 3.15 Amp, 250 volt Slo-Blo. Estimated Shipment Time (After Receipt of Order):  7 Day(s)

Fuse (4.0 Amp / 250 VAC / Time Lag Slo-Blo). Estimated Shipment Time (After Receipt of Order):  7 Day(s)

Signature® Flowmeter Voltage Stabilizer.  This alteration allows for solar chargers with voltage outputs higher than 14.25 VDC to be used with the Signature® Flowmeter.  Solar charge regulators consistently exceed 14.25...

Liquid crystal display (LCD) module.  Used on the Signature® Flowmeters. FSTN positive transflective with white light-emitting diode (LED) backlight.  Graphic controller integrated circuit (IC) not included. Number of dots:  320...

Secure digital 8-pin microSD flash card.  Used on Signature® Flowmeters, 3.3 volt. Estimated Shipment Time (After Receipt of Order):  7 Day(s)

Coin-style lithium battery 3 Volt, 220 milliampere hour. Standard discharge current 0.3 mA.   Compatible with: D-Series Syringe Pump controllers Signature® Flowmeters CombiFlash® EZ-Prep CombiFlash® Rf CombiFlash® Rf+ CombiFlash® Rf-75 CombiFlash® Rf-150...

TIENet™ Noise Reduction Service Kit.  This kit contains enough items to resolve noise on 3 sensor and 4 analog outputs. NOTE:  This kit is for Signature® serial numbers prior to...

Replacement plug sensor cap kit.  Used on 2100 Series Flow Modules and TIENet™ devices.  Includes the following: Probe cap (male) Cap assembly (male) Connector protector cap Connector cap gasket O-Ring...