Repair Parts (Glacier)

Polyethylene round bottle with two caps, 2.5 Gallon (9.5 Liter) capacity.  Includes two caps - one solid cap, the other modified with a hole to properly route the discharge tube during...

Bottle cap used on 2.5 Gallon polyethylene bottle.

Glass bottle with PTFE-lined cap and bale, 2.5 Gallon (9.5 Liter) capacity. Bottle Dimensions: Height:  13.00 Inches (33.02 cm)Outside Diameter:  8.85 Inches (22.50 cm)Throat:  5.12 Inches (13.02 cm) Note:  This bottle...

Replacement lid and liner assembly.  Used on the 2.5 Gallon glass bottle.

Composite ProPak kit.  Includes 100 composite 2 Gallon (7.5 Liter) ProPak bags, holder with cap and o-ring. Note:  This item replaced 602953029.

Replacement pump gear case assembly kit for 3700, 3700C, 3710, 3710C, GLS and Glacier Samplers.  Includes the following: Pump rotor assembly Pump housing assembly, inside Pump housing assembly, outside Appropriate...

Replacement liquid detector kit for the GLS and Glacier Sampler.  Includes the following: Liquid detector lid assembly Liquid detector base assembly Desiccant box Controller box gasket Appropriate screws 

Preventative maintenance kit for the Glacier or GLS Sampler.  Includes the following: Desiccant, 4 oz. bag Cardboard box for storing desiccant Controller gasket Humidity indicator card Trim ring Pump rotor...

Humidity indicator card.  Reversible, 3-spot relative humidity indicator (20%, 30%, 40%).  Cards change from blue color (dry) to lavender to pink (humid) as relative humidity increases.

Replacement pump gear case assembly kit for the GLS and Glacier Samplers.  Includes the following: Pump gear case assembly Desiccant, 4 oz. bag Controller box gasket Appropriate screws and nuts...

Replacement central processing unit (CPU) kit for the Glacier Sampler.  Includes the following: Control panel assembly for the Glacier central processing unit (CPU) Desiccant, 4 oz. bag Controller box gasket...

Replacement case top label kit for Glacier Sampler.  Includes the following: Glacier panel assembly Controller box gasket Desiccant, 4 oz. Appropriate screws and washers

Replacement case bottom kit for the Glacier Sampler.  Includes the following: Case bottom assembly Screws (10 each) Desiccant, 4 oz. bag

Replacement connector kit for Glacier Sampler.  Includes the following: Connector backing plate assembly Controller wiring harness Wiring harness, male connector Desiccant, 4 oz. bag Seal Appropriate screws, gasket and o-ring...

Power supply assembly for the Avalanche or Glacier Portable Refrigerated Sampler.

Temperature sensor cable assembly.

Compressor electronics modification for Avalanche or Glacier Portable Refrigerated Sampler.  Includes electronic unit. tube of silicone sealant, application stick and appropriate screws and washers.

Replacement small parts kit for the Avalanche and Glacier Refrigeration System.  Includes the following: Drain plug Connector cap strap Component clip ( 2 each) Large draw catch (2 each) Small...

Fuse 3AG, 15 amp, 32 volt Slo-Blo.

Replacement lid for Glacier refrigeration compartment.